My Skyline, the story so far… (part three)

In my last post I had just finished deleting the HICAS system, I had my first drift day looming and an ever mounting stack of parts in the garage so what was next on the list?

I wanted to make sure the car handled properly so I had bought myself a set of Daiyama adjustable coilovers from Japspeed, so I got to work fitting and setting them up. Installation was simple, after unbolting and removing the existing suspension I just slotted the new coilovers in, bolted them up and then got to work on setting the height, at this point I ran into a problem for some reason the front suspension would not go as low as the rear (and even that wasn’t particularly low!) So I ended up setting them to a more moderate ride height to even things out.

When I asked Japspeed about this I was informed that I had bought one of the last sets and that are no longer dealing with Daiyama and so could/would not be able to do anything about this issue. Ah well… At least I had some better suspension to allow me to have better control over the car…

While I had the car up in the air I decided to make a start with the swapping out the hubs for ones with 5 studs, I had bought a set of R32 GTST front hubs from my friend Joe, and managed to find some for the rear online. However since this was my first drift day I decided to leave the rear as 4 stud for the time being so that I could make use of all 4 tyres and wheels that came with on the car when I bought it. Since I was changing the front hubs and after speaking with Joe we decided that upgrading the brakes from the stock GTS calipers and discs was a good idea, as the original 4 stud discs would not fit so I sourced a set of second hand R33 GTST 4 pot brakes for the front and some 2 pot brakes for the rear (again they would be upgraded as and when I decided to do the rear hubs). I also bought new pads and discs as one thing I will not skimp on is safety.

Replacing the front hubs was a relatively straight forward affair, after removing the calipers and discs, it was as simple as unfastening a few bolts and then reversing the process to fit the 5 stud hubs. The brake upgrade was also a painless affair since I’d been given all the necessary hardware with the calipers it all went together with ease.

While the car was on stands I had also taken the diff out to have it welded up, so once that came back I threw that back in too.

now it was time to fit my new front wheels, as anyone who drifts knows its much easier to drift if you have spare wheels, and I did, the four stud wheels that were on the car when I bought it (plus a couple of spares I probably borrowed off Joe) but in order to free up the spares I had to buy something to run on the car in their place. I’d opted for a set of 16×8.75 XXR 527 wheels.

I’d liked the look of these wheels for a while and I wasn’t in the market for spending an insane amount on some genuine wheels, especially if I was going to damage them at some point! Other than being lower and having new wheels the car was still looked stock, but these wheels gave it a whole new look!

Finally as I had a Cobra bucket seat laying around from my previous car (the MR2 turbo) I threw it in the drivers side and also fitted a harness to keep me in place while going sideways, and I fitted a drift button to the hand brake so I couldn’t lock the hand brake on if I used it while drifting.

The car was now ready to hit the track!